When and how to use chlorine in a spa? Step by step guideline

Whirlpools, such as swimming pools, rely on free chlorine to kill algae and bacteria. Chlorine attacks water molecules, displacing part of the oxygen, which then kills anaerobic organisms that otherwise grow in water. Maintaining an adequate level of chlorine is important. If the level is too low, the Spa will not remain sanitary and, if the level is too high, excess chlorine can dry the skin, sometimes painfully. We suggest visiting Best Facials in Manhattan.

When to use chlorine in a spa?

Get the granular spa chlorine and some spa test strips (pool) or with which to test and adjust the water. Add only the chlorine spa for your Spa. Pool chlorine has calcium to help the pool maintain an adequate level of that chemical as well. The calcium remains dissolved in the pool because the water is relatively cold. In spas, where the water is relatively hot, calcium precipitates. Therefore, if you use pool chlorine in your Spa, you soon have calcium deposits. The only way to remove calcium deposits will be to drain the water and clean the Spa. Visit Waxing in NYC to get the best care of waxing.

Step 1: Test and adjust the spa water

Use the test strips to test the water at least once a week. It should be noted that chlorine levels are somewhere between 3 and 5 parts per million (ppm). Follow the instructions on the test strip package for the time to dip the strip and how to read the results. If your chlorine levels are too low (2 ppm or less), add the granular spa chlorine in an amount sufficient to bring the concentration of at least 3 ppm.

To raise your Spa by 1 ppm, add 2.5 Oz. of granulated chlorine per 100 liters of water volume. If you wish, you can add a little extra to take it to 5 ppm, so you won’t have to add more for a while. Don’t add too much, though, because while it’s easy to adjust chlorine levels that are too low by adding more chlorine,

When chlorine levels are very high, your only options are to add more water to the Spa to dilute the chlorine or simply to allow it to decompose over time. As most spas have a limited capacity to drink more water, most of the time, we will have to wait for chlorine levels to go down. So be careful when adding too much chlorine.

Step 2: Mix chlorine

Circulate the Spa to mix the chlorine in the well water. If you are not sure that you have added enough, after you have circulated it long enough to mix the chlorine in, try it again to check what the new levels are chlorine and add more if necessary. After you have had some chlorination experience of your Spa, you can get a good idea of ​​the amount you need each week, and you won’t have to continue with this.

Step 3: Reduce chlorine in the Spa

  • Remove the spa cover and let the chlorine dissipate in the air.
  • Let sunlight to get in touch with the spa water. Ultraviolet radiation breaks down the chlorine.Wait 24 hours. Chlorine levels decrease as it is combined with contaminants.
  • Drain a portion of the water and replace it with fresh water, if elevated chlorine levels are maintained.
  • Granular sodium di-chloro is the only chlorine product recommended for use in hot springs.

Chlorine is used in spas to disinfect water. Bacteria, algae and other harmful microorganisms are killed. It is also combined with ammonia and nitrogen from oil and sweat. Free chlorine levels are recommended to fall between 1.5 and 3 ppm. After the Spa is super-shock to dissolve contaminants, chlorine levels can be as high as 8 to 10 ppm. You should not use spas until the levels fall back to the normal range.

Finally we recommended Spa in Manhattan and Best nail Salon in Manhattan to know more details.